Apple Holder
Main Box
Outer Wrapper
After finishing putting together the final product box, there was one or two little aspects of it that didn't quite work as anticipated. The main one being the closing tab at the top, this didn't close fully as shown below. The reason being is that I didn't take into account the extra space needed for the box to rest against the glued tabs on the inside of the 'Outer Wrapper' section. This ultimately meant that there was about half a centimetre between the two sides.
Another problem was because I didn't consider the thickness of the stock when doing test prints and fits, this resulted in bowing of some sides as the box exceeded the size of the base of the outer wrapper by roughly 2mm.
No comments:
Post a Comment